Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1A. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A. Attach Side Base Frames (B) to Center Base Frame (A) using:
4 - (#1) M10x75mm Hex Head Bolt
8 - (#4) M10 Flat Washer
4 - (#5) M10 Nylon Lock Nut
2 - (E) Steel Plate
8
Advertisement
