Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tightened to fully go on.
1A. Attach Front Base Frame (A), Rear Base Frame (B) & Guide
Rods (F) together using:
2 - (#2) M10x75mm Hex Head Bolt
4 - (#12) M10 Flat Washer
2 - (#16) M10 Nylon Lock Nut
1 - (M) Steel Bracket
12
Advertisement
