Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Base Frames (A & B) to Weight Stack Frame (WA) using:
8 - (#2) M12X35mm Hex Head Bolt
16 - (#50) M12 Flat Washer
8 - (#40) M12 Nylon Lock Nut
1B. Attach Right Upright (C) to Right Base Frame (A) using:
2 - (#3) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
1C. Attach Left Upright (D) to Left Base Frame (B) using:
2 - (#3) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
22
Advertisement
