Table of Contents
Advertisement
2.4 Mounting Finger Vein Controller
The finger vein controller has a built-in reader working as an entry reader, so it should
be installed close to the door where it guides. As a common rule, the finger vein
controller should not be installed on a metal, which will lower the card sense range.
The finger vein controller package contains a supporting frame to elevate the
controller in order to make wire connections more convenient. The installation is
described in the steps below:
Step 1: Mount the supporting frame on to the wall.
Use the four anchor screws (provided in the package) to mount the frame to the wall.
Step 2: Make cable hole
In the terminal area, marked as 1 in step 1 of the figure, make a hole on the wall, big
enough to allow all the wires go through. Note the wiring diagram will be addressed in
the following sections. Wire all the required cables before step 3.
Step 3: Mount the finger vein controller to the supporting frame
Align the finger vein controller to the 4 latches (marked as 2 to 5 in step 1 figure) on
the frame, and attach the controller to the frame (marked as 1 in step 2 figure). Make
sure the latches are in position. Then push down the controller a little bit to lock the
position (marked as 2 in step 2 figure).
Step 4: Lock the screw at bottom
Secure the controller to the base board by tiding the screws at bottom of controller
(exclusive screw driver is provided in the controller package).
Note: the screw has to be fastening to push down (secure) the tamper switch.
Step 1
Step 2
1: Terminal Area
2-5: Latches
3
2
1
5
4
9
Advertisement
Table of Contents
