Pontiac tempest 1968 Service Manual page 513

7F-12
1968 P O N T I A C SERVICE MANUAL
PRESSURE
REGULATOR VALVE
DETENT SPRING
ASSY.
SOLENOID
WIRE
RETAINING
CLIP
SOLENOID
CONNECTOR
F i g . 7 F - 2 5 Transmission - O i l Pan and Strainer Removed
6. Connect solenoid connector to case terminal
(Fig. 7F-25). Make certain that case terminal r e ­
taining finger engages connector and wire is r e ­
tained by clip.
7. Install new oil strainer pipe to case seal on oil
strainer pipe and lubricate.
8. Install oil strainer assembly and tighten oil
strainer bolt to 10 lb. ft. torque.
9. Install oil pan, using a new gasket. Tighten oil
pan bolts to 12 lb. ft. torque.
7. Support transmission and remove frame cross
member.
8. Lower transmission and engine assembly to
gain access to cooler line fittings. Disconnect cooler
lines, using a crow foot adapter and suitable exten­
sion or using oil cooler pipe wrench J 22731.
NOTE: On some cars it may be necessary to
loosen exhaust system,,
9. With transmission in lowered position, remove
case to engine bolts.
10. Move transmission down and to the rear and
install converter holding strap J 21366 to hold con­
verter in position until transmission is to be dis­
assembled.
To install transmission, reverse the above proce­
dure.
TRANSMISSION DISASSEMBLY
Service procedures for rear bearing retainer,
speedometer drive gear, governor vacuum modu­
lator, speedometer driven gear assembly, downshift
solenoid, pressure regulator and valve body are
covered under SERVICE OPERATIONS - TRANS­
MISSION IN CAR, page 7 F - 3 .
REMOVAL OF VALVE BODY, REAR BEARING
RETAINER, SPEEDOMETER DRIVE GEAR,
AND LOW SERVO
1. Mount transmission in holding fixture J 8763
(Fig. 7F-26).
2. With transmission in horizontal position, pull
out converter.
TRANSMISSION
REMOVAL AND INSTALLATION
1. Disconnect speedometer cable and remove
speedometer drive gear to allow oil to drain during
removal procedure.
2. Remove propeller shaft (see section 4C).
3. Disconnect vacuum line and downshift switch
lead.
4. Disconnect shift control linkage from outer shift
lever,
5 . Remove flywheel housing bottom cover.
6c Remove flywheel to converter mounting bolts.
After bolts are removed, make certain converter hub
is free of crankshaft.
1
I
J 8763-01
fes??."*.
F i g . 7 F - 2 6 Transmission Mounted in Holding Fixture