Pontiac tempest 1968 Service Manual page 488

T U R B O H Y D R A - M A T I C TRANSMISSION 7E-53
F i g . 7 E - 1 4 6 Installing Intermediate Backing Plate and
Clutch Plates
b. Mount dial indicator J 8001 on rod and index
with end of output shaft.
c. Move output shaft in and out to read end
play. End play should be from .003"-.019". The
selective washer controlling this end play is a
steel washer having 3 lugs and is located between
thrust washer and rear face of transmission case.
If a different washer thickness is required to bring
end play within specifications, it can be selected
from the following chart:
DIAL I N D I C A T O R
. 1
J 2 1 9 0 4
I f
t
FRONT BAND
• ^ 4
• i P
1
v
F i g . 7E-148 Installing Front Band
Thickness Notches and/or Stamped No.
.074 - .078
.082 - .086
.090 - .094
.098 - .102
.106 - .110
.114 - .118
None
1 Tab Side
2 Tab Side
1 Tab. O.D.
2 Tabs O.D.
3 Tabs O.D.
15. Install front band with anchor hole placed
over band anchor pin and apply lug facing servo
hole (Fig. 7E-148).
V
4»
i
'4 .
F i g . 7 E - 1 4 7 Checking Rear Unit End Play
F i g . 7E-149 Installing Manual Shaft to Case