Pontiac tempest 1968 Service Manual page 211

5 C - 8
1968 P O N T I A C SERVICE MANUAL
POWER BRAKE ASSEMBLY—INSTALL
TORQUE SPECIFICATIONS
1. Place power brake into position and install four
rear housing to dash attaching lock washers and nuts
from inside of car. Tighten nuts to 25 lb. ft. torque.
2. Attach clevis to brake pedal and install pin and
retainer.
NOTE: Pedal height is not adjustable.
3. Adjust stop light switch if necessary to provide
3/16" plunger extension from body. Attach wire.
4. Attach vacuum hose to vacuum check valve.
5. Attach hydraulic lines.
6. Bleed brakes as necessary and fill fluid reser­
voirs. Fluid level should be as shown in Section 5.
Power cylinder housing to
master cylinder nuts
25 lb. ft.
Rear housing to dash nuts 25 lb. ft.
J 6407-2
/
J 8433
' 4
i
1
J 22553-
I I P
J 22733
J 7723
4
J 9504
Fig. 5 C - 8 Special Tool Combination