CHASSIS ELECTRICAL SERVICE
12-25
F i g .
1 2 - 1 9
Generator and Foreword Lamp Harness Installation—Firebird
Tempest Standard System and F i r e b i r d
1. Allow motor to stop i n park position.
view E . This positions the ends to the rear of the
stop on the lower edge of the moulding. The left
blade must be on top of the right blade.
NOTE:
When checking for correct
wiper
position
always make tests with a wet windshield.
Tempest Optional System Models
NOTE:
Motor must be in park
position.
1. Remove screen from cowl.
2. Remove right arm and blade assembly.
3. Loosen adjustable retainer at motor crank a r m .
4. Position left blade and a r m assembly against
stop on moulding.
5. Tighten adjustable retainer.
6. Install right arm and blade assembly against
stop on moulding.
2 . Install both right and left a r m and blade assem
blies so that end of blade is 1" above bottom of
windshield,
NOTE:
With standard Tempest system do not at
tempt to place arm and blade assemblies
against
stops on moulding.
REMOVE
WIPER
MOTOR
1. Remove hoses and wire terminals connected to
wiper unit.
2. Pontiac models - Remove retainer securing
wiper crank to wiper transmission linkage.
NOTE:
This can be done by removing plastic
plug
from
left side of upper shroud, directly
above
wiper
motor.
7. Install screen.
3. Tempest Optional System Models - Remove