S T E E R I N G
9 - 4 5
F i g . 9-83 Installing Pump Ring
F i g . 9-85 Pump Vanes Installed
plunger. Be sure end with screen goes Into bore
first.
1 3 . Install mounting bolt and union O-rings.
14. Drop reservoir into place and press down until
reservoir seats on housing.
1 5 . Install studs, torque to 35 ft. lb., and outlet
union, and torque to 35 ft. lb Install drive shaft key.
Support shaft on opposite side of key when installing
key.
INSTALLATION OF STEERING PUMP
(Figs. 9-88 and 9-89)
1. Position pump assembly on mounting bracket
with holes lined up and install bolts loosely.
2. Slide pulley on shaft. DO NOT hammer on
pulley.
3. Install pulley nut finger tight.
4. Connect and tighten hose fitting.
Tighten out
let fitting to 25 ft. lb. torque.