THREE SPEED S A G I N A W M A N U A L TRANSMISSION
7 B - 7
F i g . 7 B - 9
Removing Front Bearing
20. Remove first speed synchronizer snap ring
(Fig. 7B-15).
21. Support first speed gear on press plate, using
two (2) pieces of stock 6" x 1-7/8" x 1/4" (Fig.
7B-17). Remove first speed synchronizer assembly
and first speed gear.
22. Remove second-third speed synchronizer snap
ring (Fig. 7B-15).
23. Support second speed gear on press plate,
using two (2) pieces of stock 6" x 1 7/8" x 1/4" (Fig.
7B-18).
Remove second-third speed synchronizer
assembly and second speed gear.
_
_
^
i
F i g . 7B-11
Removing Mainshaft
CLEANING
AND
INSPECTION
1. Check synchronizer h u b s ,
sliding keys and
springs and, if necessary, replace.
NOTE:
The synchronizer hubs and sliding
sleeves
are a selected
assembly
and should be kept to
gether as originally
assembled.
a. Mark hub and sleeve so they can be reas
sembled in same position.
b. Remove sliding sleeve from synchronizer
hub. Remove keys and springs from hub.
c. Replace the
three (3) keys a n d two (2)
springs in position (one on each side of hub) so
R E V E R S E IDLER G E A R
S N A P R I N G
J S C R E W D R I V E R
F i g . 7 B - 1 0 Removing Reverse Idler G e a r Snap Ring
F i g . 7B-12
Expanding Extension Housing Snap Ring