Pontiac tempest 1968 Service Manual page 708

ACCESSORIES
15-23
RADIO
REMOVE AND REPLACE PONTIAC RADIO
(Figs.
15-34 and
15-48)
1. Remove stereo tape player, If so equipped,
2. Remove knobs, springs, nuts and bezels from
control bushings. Use J 8653 to remove nuts.
3. I f car is equipped with A / C , remove three
phillips screws holding bottom A / C a i r duct and
remove duct.
4. Disconnect stereo multiplex plug from radio,
if so equipped.
5. Remove antenna lead-in and speaker connector.
6. Remove hex screw holding right side of radio
to brace.
7. Disconnect dial light socket and lower radio
to floor.
8. Remove Multiplex Adapter, i f so equipped. (See
Below).
9. To replace, reverse above procedure.
REMOVE AND REPLACE PONTIAC FRONT SPEAKER
(Fig. 15-34)
1. Remove radio as outlined above.
2. Remove four 3/8" nuts from speaker to speaker
brace and remove speaker.
3. To replace, reverse the above.
LOCATOR PINS MUST ALIGN
WITH HOLES IN RECIEVER
FOR PROPER INSTALLATION
AM RADIO
VIEW IN DIRECTION OF ARROW A
INSTRUMENT PANEL
WIRE HARNESS
WARNING FOR KNOB ASSEMBLY INSTALLATION:
ALIGN SPRING SIDE OF KNOB WITH FLAT ON
CONTROL SHAFT. HOLDING THIS INDEX POSITION,
PUSH KNOB ONTO CONTROL SHAFT UNTIL IT
BOTTOMS. IF BOTTOMING OCCURS BEFORE REACHING
FULL-ON POSITION, IT IS PROBABLY BECAUSE THE SHAFT
HAS NOT YET ENGAGED THE KNOB FLAT. WHEN THIS
OCCURS TURN KNOB SLIGHTLY UNTIL IT DROPS INTO
FULL-ON POSITION. DO NOT ROTATE KNOB THROUGH FULL TRAVEL
IN EITHER DIRECTION UNTIL KNOB IS IN THE FULL-ON POSITION.
INSTRUMENT
PANEL BRACE
WITH FM RADIO
Fig. 1 5 - 3 4 Radio Receiver and Front Speaker—Pontiac