Pontiac tempest 1968 Service Manual page 224

SIX C Y L I N D E R E N G I N E
6 - 7
ENGINE BLOCK
I N S U L A T O R A S S Y .
CROSSMEMBER
V S E W - A
(6 CYL. E N G . -BOTH SIDES)
(BOTH S I D E S )
insulator-to-engine bracket bolts and tighten to 5 0
lb. ft
Q
DRIVE BELTS-ADJUST (EXCEPT TIMING BELT)
Engine fan and accessory drive belts may be ad­
justed by use of the Burroughs Belt Tension Gauge.
Belt Tension Specifications are given i n Section 6 A .
ENGINE-REMOVE AND INSTALL
REMOVE
1. Disconnect battery cables at battery
a
Fig. 6-8 6 C y l . Engine Mounting —Tempest
2
Q
Drain cooling system.
3. Scribe alignment marks on hood around hood
hinges and remove hood from hinges.
4. Disconnect engine wire harness and engine-to-
body ground straps
0
5. Remove a i r cleaner.
6. Remove fan shield or shroud.