Pontiac tempest 1968 Service Manual page 458

T U R B O H Y D R A - M A T I C TRANSMISSION
7 E - 2 3
ROLLER CLUTCH.
ASSEMBLY
REACTION
CARRIER
SUN ,
GEAR
PLASTIC GEAR
RING \
OUTPUT-
CARRIER
SNAP RING
/
/
Fig. 7E-54 Removing Output Shaft to Carrier Snap Ring
Fig. 7E-52 Removing Reaction Carrier and Roller
Clutch from Output Carrier
11. Remove output shaft to rear internal gear
thrust bearing and two (2) races.
1 2 . Remove rear internal gear and mainshaft (Fig.
7E-57).
NOTE: Do not drop bearings.
1 3 . Remove rear internal gear to sun gear thrust
bearing and two (2) races.
14. If necessary, remove rear internal gear to
mainshaft snap ring to remove mainshaft (Fig.
7E-58).
G O V E R N O R ASSEMBLY
All components of governor assembly, with ex­
ception of driven gear, are a select fit and each
assembly is calibrated. The governor, including
the driven gear, is serviced as a complete assem­
bly. However, the driven gear can also be serviced
separately.
Fig. 7E-53 Removing Sun Gear Fig. 7 E - 5 5 Removing Speedometer Drive Gear