Pontiac tempest 1968 Service Manual page 66

CUSTOM A I R C O N D I T I O N I N G 1A-39
3. Remove control panel.
4. Disconnect cable at cam assembly,
5. Remove cable.
6. To replace reverse removal procedure,,
DIVERTER CABLE
FIREBIRD
1. Remove control panel.
2. Disconnect cable at control panel.
3. Remove glove compartment.
4. Disconnect cable at heater case.
5. Remove cable.
6. To replace reverse above procedure.
DEFROSTER CABLE
FIREBIRD
1. Remove ash tray and cold air ducts.
2. Remove defroster extension retaining screws.
3. Remove defroster extension.
4. Remove cable at extension.
5. Remove radio and ash tray bracket.
6. Drop control panel and remove cable.
7. To replace reverse removal procedure.
CONTROL PANEL-REMOVE AND REPLACE
(Fig. 1A-55)
In servicing individual components of the control
panel assembly, the assembly should be removed
from the instrument panel as follows:
PONTIAC
1. Disconnect battery.
2. Remove lower duct and outlet assembly.
3. Remove wire and vacuum connections.
NOTE: Identify wire connectors to switches and
vacuum connectors for correct reassembly and
remove.
4. Remove blower switch and temperature control
knobs and escutcheon nuts.
5. Lower control panel assembly.
6. Remove temperature control cable and remove
control.
7. Replace by reversing the above procedures.
CAUTION: Do not reverse leads.
T E M P E S T (Fig. 1A-56)
1. Remove cold air distributor duct.
2. Remove control panel attaching screws.
3. Drop panel from instrument panel area.
4. Mark and remove vacuum harness connector.
5. Remove cables and light.
6. Remove blower connector.
7. To replace reverse removal procedure.
8. To adjust cables see Cable Adjustment.
FIREBIRD
1. Remove screws retaining lower portion of trim
plate to instrument panel. Remove trim plate.
2. Remove distribution duct.
3. Remove radio.
4. Remove retaining screws and remove control
panel.
5. Lower control panel from instrument panel
and r e m o v e cables, vacuum hoses and wire
connectors.
6. To replace reverse removal procedure.
HI BLOWER RELAY
PONTIAC ONLY
1. Remove wire connector from relay. (Rear relay
on bracket).
2. Remove relay retaining screws.
3. Remove relay.
4. To replace reverse removal procedure.