Pontiac tempest 1968 Service Manual page 410

7C-1
FOUR SPEED SAGINAW MANUAL TRANSMISSION
CONTENTS OF THIS SECTION
SUBJECT PAGE SUBJECT PAGE
Description 7C-1
Periodic Service . . . See Section 7B
On Car Adjustments 7C-1
Minor Repairs
Extension Housing Seal See Section 7B
Extension Housing Seal & Bushing See Section 7B
Transmission Side Cover-R&R 7C-1
Major Repairs
Transmission - Remove See Section 7B
Transmission - Disassemble 7C-3
Cleaning and Inspection See Section 7B
Mainshaft - Assemble 7C-6
Countergear - Assemble See Section 7B
Transmission - Assemble 7C-8
Transmission - Install See Section 7B
Driveline Damper - Firebird Only 7C-9
Specifications
Transmission Identification . 7C-9
Gear Ratios 7C-9
Lubrication 7C-9
Torque Specifications 7C-9
Special Tools . - See Section 7B
DESCRIPTION
The Saginaw 4-speed transmission is used on all
Tempests and Firebirds when a 4-speed is ordered
with the 6-cyl. engine. It has all forward gears
synchronized with a constant mesh reverse idler.
Since the Saginaw 4-speed is very similar to the
Saginaw 3-speed transmission, many operation pro­
cedures are the same. In such cases, a note will be
made to refer to the Three Speed Saginaw Manual
Transmission Section, Section 7B.
PERIODIC SERVICE
REFER TO SECTION 7B
ON CAR ADJUSTMENTS
SHIFT LINKAGE ADJUSTMENT (Fig. 7C-1, 7C-2)
1. Position selector lever in neutral position.
2. Loosen trunnion jam nuts on transmission gear­
shift control rods.
3. Place transmission lever and bracket assembly
in n e u t r a l position a n d install gauge pin as
illustrated.
4. Position levers on transmission in neutral.
5. Retorque trunnion jam nuts to 30 lb. ft.
6. Remove gauge pin and check complete shift
pattern.
MINOR REPAIRS
EXTENSION HOUSING SEAL
Refer to Section 7-B.
EXTENSION HOUSING SEAL & BUSHING
Refer to Section 7-B.
TRANSMISSION SIDE COVER-
REMOVE AND DISASSEMBLE
The following procedure may be performed with
the transmission in or out of the car.
1. Disconnect linkage from shift levers on trans­
mission, leaving it in neutral.
2. Loosen side cover bolts and allow transmission
to drain.
3. Remove side cover from case.
4. Remove outer shifter levers.
5. Remove both shift forks from shifter shaft as­
semblies. Remove all three shifter shaft assemblies.
Remove reverse shifter shaft detent ball and spring.
(Fig.
7 C - 3 )
6. Remove detent cam spring and pivot retainer
C-ring. Mark to identify both detent cams and
remove.
7. Inspect O-ring seals on shifter shafts. Replace
any damaged parts.