Pontiac tempest 1968 Service Manual page 505

7F-4 1968 P O N T I A C S E R V I C E M A N U A L
H A N D L E MUST B E I N S T A L L E D A F T E R
C O N S O L E P A R T S A R E A S S E M B L E D
S T A R T E R N E U T R A L I Z E R SWITCH I N S T A L L A T I O N
1. POSITION G E A R S H I F T L E V E R IN D R I V E POSITION.
2. I N S E R T SWITCH D R I V E TANS IN SWITCH L E V E R AND
A S S E M B L E SWITCH TO S H I F T E R A S S E M B L Y .
3. I N S E R T ADJUSTING G A G E IN SWITCH. MOVE G E A R S H I F T
L E V E R T O P A R K POSITION & REMOVE ADJUSTING G A G E
SWITCH R E S E T ( I F R E - A D J U S T M E N T IS R E Q U I R E D )
4 . I N S E R T B L A D E O F R E S E T G A G E IN S L O T
5. MOVE G E A R S H I F T L E V E R SLOWLY TO LOW POSITION.
6. R E M O V E R E S E T G A G E AND R E P E A T S T E P 3.
UNDERBODY
ADJUSTMENT G A G E
TRANSMISSION
R O T A T E TRANSMISSION L E V E R
CLOCKWISE TO " P A R K " POSITION.
ADJUST PIN TO THIS DIMENSION
PRIOR TO I N S T A L L A T I O N O F C A B L E .
VIEW C
F i g . 7 F - 3 Tempest Floor S h i f t Linkage
2. Remove speedometer cable and speedometer
driven gear assembly,
3. Remove rear bearing retainer.
4. If necessary, replace speedometer drive gear.
Remove by depressing clip (Fig. 7F-27), Install new
gear.
5. Pry out old oil seal.
6. Remove old case to rear bearing retainer oil
seal.
7. Remove old rear bearing retainer bushing, using
bushing chisel J 8400-1 (Fig. 7F-9).
8. Install new bushing from rear, using installer
J 21424-1 and handle J 8092 (Fig. 7F-10).
9. Coat outer casing of new oil seal with gasket
sealing compound and drive it into place with in­
staller J 5154 (Fig. 7F-8).
10. Install new case to rear bearing retainer oil
seal.
11 o Install rear bearing retainer. Tighten bolts to
30 lb. ft. torque.
12. Install propeller shaft (see section 4C).
13. Install speedometer driven gear and connect
cable.
GOVERNOR
REMOVAL
1. Remove three bolts retaining governor cover to
case. Remove cover and gasket.