H E A T I N G A N D V E N T I L A T I O N
1-7
F i g . 1-6
Control Diaphrams-—Pontiac
FIREBIRD
1. Disconnect battery ground and positive cables,
and remove battery and tray (Fig. 1-9).
2. Unclip heater hoses from fender s k i r t ,
3. Scribe alignment marks and remove hood.
4. Remove right front fender
and s k i r t as an
assembly.
5. Disconnect the blower motor wire at the motor
flange.
6. Either
remove
the
motor to case mounting
screws and remove motor or remove the two screws
and five nuts at dash to remove motor and duct as
sembly.
Pry duct gently i f the sealer acts as an
adhesive.
7. Remove
the blower wheel
retaining nut to
separate blower and motor.