Daily Use Of Sound Modes And Speaker Groups - Bang & Olufsen BeoVision 14-40 User Manual

In Options in the LIST menu, you can choose to either start playback or play back a
highlighted recording from the beginning. You can also resume a recording from where
you left off, or remove a recording.
In addition, you can press the red button to remove a recording or a scheduled
recording.
Press the green button to adjust the time of a recording or scheduled recording.
In the list of recordings, use the yellow button to rename a recording. In the list of
scheduled recordings, use the yellow button to set a reminder or recording.
During playback of a recording, you can press LIST, bring up the Options menu and make
settings for subtitles, subtitle language and audio language.

Daily use of sound modes and speaker groups

You can extend your television into a surround sound system by adding BeoLab
loudspeakers and subwoofers.
When you switch on a source, the television automatically selects the appropriate
sound mode for the source you are using. However, you can select another sound
mode at any time.
Also, when you switch on the television, the TV speaker group is selected
automatically. However, you can always select another group of activated speakers if
you want to listen to music without having to sit in front of the television, for example,
when you sit at the dining table or in an armchair.
You can adjust the settings of the sound modes and set up speaker groups. For more
information about sound modes and speaker groups, press the red button in the on-
screen help and find 'Sound modes' and
Select a sound mode
You can select the sound mode that suits the source you are using.
1. Press LIST, then  or  to bring up SOUND in the BeoRemote One display
and press the centre button.
2. Press  or  to highlight the sound mode you want and press the centre
button.
3. Press  or  to step between modes.
4. Press  to remove SOUND from the display.
When you configure a source, you can set a sound mode to be selected automatically
each time you switch on the source. For information about preset selection, press the red
button in the on-screen help and find
Select a speaker group
Select the speaker group that suits your listening position.
1. Press LIST, then  or  to bring up SPEAKER in the BeoRemote One display
and press the centre button.
2. Press  or  to highlight the speaker group you want and press the centre
button. The selected speakers cut in automatically.
3. Press  or  to step between groups.
4. Press  to remove SPEAKER from the display.
When you configure a source, you can set a speaker group to be selected automatically
each time you switch on the source. For information about preset selection, press the red
button in the on-screen help and find
'Create a speaker group'.
'Create a speaker group'.
'Create a speaker group'.
36