Smart Card For Digital Channels; Connect Speakers To The Television - Bang & Olufsen BeoVision 14-40 User Manual

For information about download of Peripheral Unit Controller (PUC) tables for set-top
boxes, press the red button in the on-screen help and find

Smart Card for digital channels

If you want to watch coded channels, contact your service provider. The service provider
will register you as an authorised viewer, usually requiring payment. You will then be
provided with a Smart Card and a CA Module. Note that these will only be valid for one
service provider and therefore only work with certain channels.
The CA Module is a 'card reader' for your Smart Card which decodes the coded signals
sent out by the service provider. Only uncoded digital channels, also known as 'free-to-
air' channels, are available without Smart Cards and CA Modules.
Contact your Bang & Olufsen retailer for information about compatible CA Modules.
The Smart Cards must remain in the CA Modules, unless your service provider asks you
to remove it. This is important in case your service provider wishes to send new
information to your Smart Card.
Insert a Smart Card carefully into a CA Module. The CA Module has one protruding edge
on one side and two protruding edges on the other side. If the television does not receive
any signal, check that the Smart Card and CA Modules are inserted correctly.
Smart Cards and CA Modules may also give access to special menus which are not
described here. If this is the case, follow the instructions from your service provider. You
can access a Common interface menu when the TV tuner is the current source if you
press LIST and bring up Options.
When operating your television, you may need to use different pin codes other than a pin
code for your Smart Card. Pin codes are used for protective reasons, due to mandatory
requirement from providers and by external equipment. It may be easier for you if you
choose the same code for different systems when possible.

Connect speakers to the television

You can connect up to eight wired speakers and subwoofers to the television using
Power Link cables.
In addition, you can connect up to eight speakers wirelessly, including subwoofers. For
more information about setting up wireless speakers, press the red button in the on-
screen help and find 'Sound settings'.
Disconnect all systems from the mains before you connect additional products.
Depending on the type of speakers you connect to the television, different cables and
maybe also adaptors are needed. Cables and adaptors are available from your Bang &
Olufsen retailer.
The illustration shows an example of a speaker setup with two front speakers, two daisy-
chained rear speakers and a subwoofer.
Connect speakers
1. Connect a Power Link cable to the appropriate socket on the speakers you wish
to connect to the television.*
2. Run the cables to available sockets marked PL 1–4 on the television.
3. Connect a Power Link cable to the appropriate sockets on a subwoofer.
4. Run the cable to an available socket marked PL 1–4 on the television.
5. Reconnect the television and the connected speakers to the mains.
*Remember to set the switch for left and right position on the speakers depending on
whether your speaker is positioned on the left or right of your listening position.
'PUC tables'.
19