Connect A Computer; Connect An Analogue Audio Source; Ir-Transmitters - Bang & Olufsen BeoVision 14-40 User Manual

setting. You can change this setting temporarily in the Picture menu. Press
the red button in the on-screen help and find
Connect a camera
1. Connect the cable to the appropriate socket on the camera.
2. Run the cable to an HDMI IN socket on the television.
3. Follow on-screen instructions to configure the source.

Connect a computer

Before you connect a computer, you must disconnect the television, the computer and all
connected products from the mains supply.
1. Using the appropriate type of cable, connect one end to the DVI or HDMI output
socket on your computer, and the other end to an HDMI IN socket on the
television.
2. If you use the DVI output socket on the computer, use the appropriate cable and
connect the sound output on the computer to the L/R IN socket on the
television to hear sound from the computer in the speakers connected to the
television.
3. Reconnect the television, the computer, and all connected products to the
mains. Remember, the computer must be connected to a grounded wall outlet
as specified in its setting-up instructions.
4. Follow on-screen instructions to configure the source.

Connect an analogue audio source

You can connect one analogue audio source, such as an Mp3 player. To configure
products connected to the television, press the red button in the on-screen help and find
'Set up connected products'.
Disconnect all systems from the mains before you connect additional products.
1. Connect the cable to the appropriate socket on the product you wish to
connect.
2. Run the cable to the L/R IN socket on the television.
3. Reconnect the television and the connected products to the mains.
4. Follow on-screen instructions to configure the source.
Different adaptors and possibly also cables are needed. Cables and adaptors are
available from your Bang & Olufsen retailer.

IR-transmitters

To operate non-Bang & Olufsen products with a BeoRemote One or the BeoRemote App,
attach a Bang & Olufsen IR-transmitter on your non-Bang & Olufsen product and then
connect it to one of the sockets marked PUC on the connection panel. Attach the
transmitter near the IR-receiver on the connected product to ensure remote control
operation. Before attaching the transmitter permanently, check that you can operate the
product menus on the TV screen using BeoRemote One or BeoRemote App. Operation
of your television with the BeoRemote App may not be available in the current software
version.
When you set up the transmitter to a selected PUC socket in the Source list menu,
settings for the IR-transmitter are made automatically. However, it is possible to perform
a manual setup of the socket if alternative settings are required.
For an extra PUC cable, contact your Bang & Olufsen retailer.
'Picture settings' for more information.
18