Overview; Run Cables; Fasten The Speaker Cover - Bang & Olufsen BeoVision 14-40 User Manual

Set the maximum angle the television will turn on the motorised floor stand or wall
bracket. The wall bracket without a motor can manually be turned 90˚ left or right
depending on your setup. Remember to leave enough space around the television to
allow it to turn freely. For more information, press the red button in the on-screen
help and find 'Set a stand position'.

Overview

Locate the connection panel and other important items:
1. Holes for mounting of a wall bracket.
2. Holes for mounting of a stand.
3. Covers for the connection panel. Pull out at the bottom to remove the cover
parts.
Depending on your setup, lead the cables through the hole in the middle or either sides
of the connection panel cover.

Run cables

Gather the cables from each side, make the bundles cross each other, and fasten them to
either side or in the middle, depending on wall bracket or stand placement.
If you have a motorised stand or wall bracket, make sure that there is enough slack in the
cables to allow the television to turn to either side or tilt before you fasten the cables
with cable ties to make a neat bundle.

Fasten the speaker cover

When the television is placed on a wall bracket or stand you can attach the speaker
cover. Hold the speaker cover with both hands and attach it at the bottom first. Then
carefully attach it to the top and adjust its position before letting go.
During cleaning it is recommended to remove the speaker cover. Avoid spraying liquid
directly on the screen as this may damage the speakers, use a soft cloth
instead. Carefully remove the speaker cover by supporting it in the side and at the
bottom.
If you have a wooden speaker cover, note that wood is a living and natural material and
12