LifeSpan entertainer Owner's Manual page 19

1. The relative line of the
control motor are abnormal.
2.Do not press START KEY.
The motor
will not
3.Safety pull pin not inserted
work.
4.Motor plug is loosen or the
motor is faulty.
5.Power or controller
specification is wrong.AC
（220~240）V
SENSOR does not touch
No speed
well.
Pa circuit board bolt does not
PA circuit
lock well or not put the
board
connector well.
SENSOR does not touch
well.
No hand
pulse
The hand pulse does not
touch well
Message failure
E01
ENTERTAINER
switch is opened.
1. Checking the line of the
control motor is plugged
well.
2.Checking the button is
valid or not started the
switch ?.
3.Checking the safety pull
pin is plugged well.
4.Testing if the motor is
faulty.
5.Checking the
specification.
1.Checking the distance
and place between
SENSOR and magnet.
2.Checking the wire if
circuit breaker tripped.
3.Checking the wire tie-in
if it is touched well.
Take apart the bottom
cover and press PA circuit
board to see if it is short
circuit or loosen.
1.Checking the wire is
short circuit or loosen.
2.Checking the wire and
computer if the tie-in is
connected well.
3.Put both hands to bedew
a little or scrub with both
hands.
1.the connected wire is
wrong.
18
- -
1. Insert the control motor wire.
2.Reset the START KEY to
test.
3.Insert safety pull pin.
4.Change the motor
5.To choose the correct
specification to reset the
testing.
1.Adjust the distance within
5m/m.
2.Change the wire or SENSOR
3.Reset to insert the wire tie-in.
Reset to put the connector?
and lock the bolt.
1.Change the wire or reset.
2.Reset to insert the wire
3.Reset to test.
1.Use the multimeter to test the
wire is stand or fall.