Operation Using The Supplied Infrared Remote Commander; Before Operating; Turning On The Power - Sony SRG-360SHE Operating Instructions Manual

Operation Using the Supplied
Infrared Remote Commander

Before Operating

Before operating the camera, check that the camera and
peripheral devices are properly installed and connected.
For details, see "Setting of the SYSTEM SELECT switch"
(page 9), "Installing the Camera" (page 16) and
"Connections" (page 19).
Note
The supplied infrared remote commander may not work
correctly near the inverter lighting fixtures. In such a case,
try to install the camera far from the inverted luminaire.
You can check whether or not the installed location is
good for the usage of the infrared remote commander.

Turning on the Power

SRG-360SHE
POWER lights.
1
Connect the camera to an AC outlet using the
supplied AC power adaptor and AC power cable or to
a LAN connector for PoE+.
The power is turned on and the POWER light turns
on.
The camera automatically pans and tilts to come to
the position stored in POSITION 1 when the power is
turned on. (Pan/Tilt reset)
After this, SDI OUT and HDMI OUT images are
output and the NETWORK light comes on. Then, all
operations become available (up to two minutes).
Note
When power is supplied via PoE+, the POWER light does
not come on until the initial authentication is completed
(the time varies depending on the model; it is
approximately one minute).
29
DC 12 V
to AC outlet