Initialize Tab - Sony SRG-360SHE Operating Instructions Manual

59.94 Hz system 1920 × 1080p/59.94 (A)
1920 × 1080p/59.94 (B)
1920 × 1080i/59.94
1920 × 1080p/29.97
1280 × 720p/59.94
1280 × 720p/29.97
50 Hz system 1920 × 1080p/50 (A)
1920 × 1080p/50 (B)
1920 × 1080i/50
1920 × 1080p/25
1280 × 720p/50
1280 × 720p/25
Notes
• To enable settings via WEB UI, select "7" for the
SYSTEM SELECT switch on the back, and turn power
on again.
• The frame rate and image size that can be selected for
the IP image may differ depending on the video format.
• After changing the video format, the PTZF position is
returned to the position originally set when starting the
camera and the video codec setting is returned to the
default setting in accordance with the SDI video format.
HDMI Video format
If you change the SDI video format, the HDMI video
format will be changed automatically.
To change the HDMI video format, change the SDI video
format.
Note
You cannot configure using this menu.
Image stabilizer
Set the image stabilizer function. Select the checkbox to
display steadier images when the camera is installed in a
place subject to vibration.
Notes
• When the image stabilizer function is set, the angle of
images taken will be smaller than usual.
• The image stabilizer may not respond depending on the
amount of vibration.
• Be sure to set this function during the installation.
Eflip
Flip an image vertically. This function is set to Off
normally. When installing the camera to ceilings, set it to
On.
Note
If you switch On/Off of the Eflip function, all preset
settings and pan-tilt limit settings are deleted. The video
codec setting is returned to the default setting in
accordance with the SDI video format.
Video format

Initialize Tab

Reboot
Used when rebooting the system.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot the
camera. It takes about two minutes to restart.
Factory default
Resets the camera to the factory settings.
Retain current network settings
Factory settings for IP
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "This System
will be rebooted. Are you sure?" appears.
When you click OK, the network indicator on the camera
starts to blink. After adjustments of the default settings
have finished, the camera reboots automatically. Do not
turn off the camera until the camera reboots.
Backup setting data
Saves the setting data of the camera in a file.
Click Backup setting data, and follow the instructions
on the Web browser to specify the folder and save the
setting data of the camera.
Restore setting
Loads the stored setting data of the camera.
Click Choose File and select the file in which the setting
data is stored. Click OK, and the camera is adjusted
according to the loaded data.
Delete superimpose logo
Click Delete to delete the superimposed logo, specified
by Position in the Superimpose tab of the Video menu,
from the camera.
To set whether to show or hide the superimpose logo, you
need to configure the setting under the Superimpose tab.
53