Connections; Connecting The Power Supply - Sony SRG-360SHE Operating Instructions Manual

Notes
• Take the proper steps to ensure that the load of the
cables connected does not cause problems.
• To prevent cables from coming off, it is
recommended to proceed to 6-2 after connecting
the HDMI cable, and then connect other cables.
6-2
To prevent the HDMI cable from coming off, mount
the HDMI cable fixing plate with the supplied screw
(single, M2.6 × 6, black) on the rear side of the
camera, then fix the HDMI cable with a banding
band etc.
HDMI cable fixing plate
Banding band
Note
Do not attach the HDMI cable on the camera unit, if
you do not use them.
7
Adjust the Eflip function to optimize the ceiling
mounting status via the Web browser or menu
display.
Note
All preset settings will return to their default when
adjusting the setting of the Eflip function. When
setting, make sure to set the Eflip function before the
preset settings.
Removing the camera
1
Remove the 3 screws used to attach the camera in step
5 of "Installation."
2
While pushing the entire camera up towards the
ceiling, move the camera to the front.
The hooks will disengage, and you can remove the
camera.

Connections

Connecting the power supply

Power is supplied to the unit using the following methods.
• Supplied AC power adapter
• PoE+* (power supply system, which complies with
* PoE+: an abbreviation of Power over Ethernet plus.
Power supply with the supplied AC power
M2.6 × 6 (Supplied)
adapter
Use the supplied AC power adaptor and AC power cord
to connect the camera to an AC outlet.
• This product is not equipped with a power switch.
• When supplying power using the AC power adapter, do
• Wait approximately 10 seconds before turning the
19
IEEE802.3at)
SRG-360SHE
to AC
outlet
AC power adaptor
(supplied)
AC power cord (supplied)
CAUTION
When installing this product, install dedicated cutoff
equipment within the fixed wiring that can be easily
accessed or connect the power plug to an outlet near the
camera where it can be easily inserted/removed. If an
abnormality occurs, apply the cutoff equipment or
remove the power plug.
not connect the PoE+ power supply system.
power on again.
DC 12 V