Operation Using The Supplied Infrared Remote Commander; Pan/Tilt And Zoom Operation; Panning And Tilting - Sony SRG-120DS Operating Instructions Manual

Operation Using the Supplied
Infrared Remote Commander
Pan/Tilt and Zoom
Operation

Panning and Tilting

STD
HOME
L/R DIRECTION
SET
1
Press the POWER switch.
The camera will turn on and perform the pan/tilt reset
operation automatically.
2
Press the arrow button to pan or tilt the camera.
While checking the picture on the screen, press the
desired arrow button.
To move the camera little by little, press the button
just for a moment.
To move the camera in a wide range, press and hold
the button.
To move the camera diagonally, press the B or b
button while holding down the V or v button.
To face the camera back to the front
Press the HOME button.
If the camera moves in a different direction from
the one you intended
The camera is preset so that the image output from the
camera is rotated toward the right whenever you press the
b button.
1
CAMERA SELECT
REV
2
PAN-TILT
RESET
To face the camera toward the opposite
direction
You might wish to face the camera toward the opposite
direction from that of the button you pressed, for
example, when you change the direction of the camera
while checking the picture on the screen. In such a case,
press the 2 (REV) button while holding down the L/R
DIRECTION SET button.
Arrow button Movement of the
To reset the setting
To reset the setting, press the 1 (STD) button while holding down
the L/R DIRECTION SET button.
Arrow button Movement of the
Note
The setting above only changes the signal emitted from
the infrared remote commander, and does not change the
setting of the camera itself. Therefore, repeat the setting
for each infrared remote commander if you are using
more than one infrared remote commander.
When the STANDBY lamp is blinking
The STANDBY lamp blinks.
If the camera is moved forcibly, or a finger or other object
interferes with camera movement, the camera may fail to
memorize the pan/tilt position.
Press the PAN-TILT RESET button to reset the pan/tilt
position.
14
Setting
camera
While holding
down
Press
Setting
camera
While holding
down
Press