Sony SRG-360SHE Operating Instructions Manual page 38

While holding down (for POSITION 1 to 8)
Press a POSITION button
you want to set.
RESET
PRESET
1 2
SHIFT
9 10
While holding down (for POSITION 9 to 16)
The settings are stored in the memory of the camera.
The pressed button flashes during storing. Flashing
stops when storing is completed.
To recall the stored settings
Press any of the GROUP/POSITION buttons in which
you have stored the settings.
For POSITION 9 to 16, hold down the SHIFT button and
press any of the GROUP/POSITION buttons.
To cancel the preset memory
While holding down the RESET button (for POSITION 1
to 8) or the RESET button and the SHIFT button (for
POSITION 9 to 16), press the GROUP/POSITION button
from which you want to cancel the settings.
While holding down (for POSITION 1 to 8)
Press a POSITION button
you want to cancel.
RESET
PRESET
1 2
SHIFT
9 10
While holding down (for POSITION 9 to 16)
The pressed button flashes during canceling of the
settings. Flashing stops when the settings have been
canceled.
Notes
• When the power is turned on, the camera starts with the
settings stored in POSITION 1.
• If you want to retain the previous pan and tilt positions
when the power is turned off and turned on again, store
those positions in POSITION 1.
• When you are storing or canceling the settings in one
POSITION, you cannot call up, store or cancel the
settings in another POSITION.
• When you store the position, zooming, and focusing,
etc. of the camera, make sure to install and secure the
camera on the place to be used properly. If you change
the installations of the camera after storing the settings,
the differences may occur in the settings.
• You can also set and store the camera settings in
POSITION 1 to 16 with operation via a network. Also,
the stored settings can be canceled with the operation
via a network.
• For the setting items can be stored and canceled, see
"Initial value and preset" on page 71.
3 4 5 6 7 8
11 12 13 14 15 16
3 4 5 6 7 8
11 12 13 14 15 16
• When you toggle the pan/tilt limit OFF to ON, the
remembered position will be cleared.
Perform the pan/tilt limit, then preset.
• Please note that if you flip the image, the set position
will be cleared.
38