Infrared Remote Commander (Supplied) - Sony SRG-X40UH Operating Instructions Manual

Infrared Remote Commander
(supplied)
 CAMERA SELECT buttons
Press the button corresponding to the
camera you want to operate with the remote
commander. The camera number can be set
using the IR SELECT switch on the back of the
camera.
Note
If two or more cameras are adjacent and
have the same camera number, they are
operated simultaneously with the supplied
remote commander. When you install the
cameras close to each other, set different
camera numbers.
For setting of camera number, see
"Operating Multiple Cameras Using the
Infrared Remote Commander" (page 22).
 FOCUS buttons
Used for focus adjustment.
Press the AUTO button to adjust the focus
automatically. To adjust the focus manually,
press the MANUAL button, and adjust it with
the FAR and NEAR buttons.
Note
Press the MANUAL button and adjust the
focus manually when shooting the following
objects.
• White walls and other objects without
contrast
• Objects behind glass
• Objects with horizontal stripes
• Objects on which bright lights are cast or
reflected
• Nightscapes and other dark objects with
blinking lights
• Lit objects shot with darkened exposure
adjustment or exposure compensation
settings
 DATA SCREEN button
Press this button to display the main menu
PAGE. Press it again to close the menu. If you
press the button when a lower-level menu is
selected, the display goes back to a higher-
level menu.
Note
You cannot perform pan/tilt/zoom
operations while the menu is displayed.
 PAN-TILT button
Press the arrow buttons to pan or tilt the
camera. Press the HOME button to face the
camera back to the front.
When the menu is displayed, use  or  to
select the menu items and  or  to change
the set values.
The selected setting menu is displayed by
pressing the HOME button when the main
menu is displayed.
 L/R DIRECTION SET button
Hold down this button and press the REV
button to change the direction of the camera
movement to be opposite the direction of
the arrows on the  and  buttons. To reset
the direction of the camera movement, press
the STD button while holding down this
button.
 POWER button
Press this button to turn on power or to put
the camera in the standby mode.
 BACK LIGHT button
Press this button to enable backlight
compensation. Press it again to disable
backlight compensation.
Note
The BACK LIGHT button is enabled when
MODE (Exposure mode) on the EXPOSURE
menu is set to [FULL AUTO] (Full auto),
[SHUTTER Pri] (Shutter priority), or [IRIS Pri]
(Iris priority).
8