Powtran PI9000-S Series User Manual page 77

input
DI2
DI3
DI4
DI5
DI6
DI7
DI8
DI5
DA1-
GND
Analog
output
DA2-
GND
SPA-COM
SPB-COM
Digital
output
SPB-COM
T/A1-
T/C1
Relay
output
T/B1-
T/C1
J12
Auxiliar
y
interface
J13
Digital input 2 bipolar input
2.Input impedance: 2.4kΩ
Digital input 3
3.Voltage range with level input: 9V to 30V
Digital input 4
4 . Below 11KW: (DI1 to DI6)drive manner
Digital input 5
is controlled by J5, when external power
Digital input 6
supply is used to drive, please unplug J5
Digital input 7
jumpers ,
5 . Above 11KW: (DI1 to DI4)drive manner
Digital input 8
Except the function of DI1 to DI4,DI6 to
High-speed
DI8,DI5 can also be used as high-speed
pulse input
pulse input channels.Maximum input
terminals
frequency: 100kHz
The selected J2 jumper on control panel
Analog output determines voltage or current output.
1 Output voltage range: 0V to 10V , output
current range: 0mA to 20mA
The selected J1 jumper on control panel
Analog output determines voltage or current output.
2 Output voltage range: 0V to 10V , output
current range: 0mA to 20mA
Digital output Opto-coupler isolation, bipolar open
1 collector output
Output voltage range: 0V to 24V , output
Digital output
current range: 0mA to 50mA
2
Subject to function code(F2.00)"SPB
High-speed terminal output mode selection"
pulse output As a high-speed pulse output, the highest
frequency up to 100kHz;
Normally
Contactor drive capacity: normally closed
open terminals
contact 5A/AC 250V，normally open
Normally
contact 3 A/AC 250V，1A/ DC 30V, COSø
closed
= 0.4.
terminals
485 card
26-pin terminal
interface
PG card
12-pin terminal
interface
73
Chapter8.Installation and Spare Circuit
is controlled by J6, (DI5 to DI8)drive
manner is controlled by J5, when
external power supply is used to drive,
please unplug J5 jumpers ,