F1 Input Terminals Group - Powtran PI9000-S Series User Manual

Chapter5.Function parameter
Acceleration time
F0.13
1
Deceleration time
F0.14
1
Maximum output
F0.19
frequency
Upper limit
F0.20
frequency source
Setting upper limit frequency. The upper limit frequency can be set from either
digital setting (F0.21) or analog input channels. If the upper limit frequency is set from
analog input, the set 100% of analog input is relative to F0.21.
To avoid the "Runaway", the setting of upper limit frequency is required, when the
inverter reaches up to the set upper limit frequency value, the inverter will remain
operation at the upper limit frequency, no further increase.
Upper limit
F0.21
frequency
Lower limit
F0.23
frequency
When the frequency command is lower than the lower limit frequency set by F0.23,
the inverter can shut down, and then run at the lower limit frequency or the zero speed;
the running mode can be set by F7.18.
F0.24 Running direction
By changing the parameters, the motor steering can be achieved without changing
the motor wiring, which acts as the adjustment of any two lines(U, V, W) of the motor to
achieve the conversion of the motor rotation direction.
Note: after the parameter is initialized, the motor running direction will be restored to
its original status. When the system debugging is completed, please use with caution
where the change of motor steering is strictly prohibited.

5-1-3.F1 Input terminals group

Code Parameter name
DI1 terminal
F1.00
function selection
DI2 terminal
F1.01
function selection
DI3 terminal
F1.02
function selection
0.00s to 6500s
0.00s to 6500s
50.00Hz to 320.00Hz
F0.21 setting
Analog AI1 setting
Analog AI2 setting
Panel potentiometer setting
High-speed pulse setting
Communication reference
F0.23 (lower limit frequency) to
F0.19(maximum frequency)
0.00Hz to F0.21 (upper limit
frequency)
same direction
opposite direction
Setting range
0～51
28
- ☆
☆
-
50.0
★
0Hz
0
1
2
★
0
3
4
5
50.0
☆
0Hz
0.00
☆
Hz
0
☆
0
1
Chan
Factory
ge
range
Limit
★
1
★
2
★
0