Table Of Contents; Safety Precautions - Powtran PI9000-S Series User Manual

Chapter1.Inspection and Safety Precautions

1-2.Safety precautions

Safety precautions in this manual are divided into the following two categories:
Danger: the dangers caused by failure to perform required operation, may result in
serious injury or even death;
Caution:the dangers caused by failure to perform required operation, may result in
moderate injury or minor injury, and equipment damage;
Process
Before
installation
When
installing
When wiring
Type
● When unpacking, if control system with water,
parts missed
do not install!
● If packing list does not match the real name, do
not install!
● Gently carry with care, otherwise there is the risk
of damage to equipment!
Danger
● Please do not use the damaged driver or the
frequency inverter with missed pieces, otherwise
there is the risk of injury!
● Do not use your hand to touch the control system
components, otherwise there is the risk of
electrostatic damage!
● Please install the unit on the metal or flame
retardant objects; away from combustible material.
Failure to do so may cause a fire!
Danger
● Never twist the mounting bolts of the equipment
components, especially the bolt with the red mark!
● Do not let the lead wires or screws fall into the
driver. Otherwise which may cause damage to the
driver!
● Keep the driver installed in the place where less
Note
vibration, avoid direct sunlight.
● When two or more converters are installed in a
cabinet, please pay attention to the installation
location, ensure the good heat dissipation effect.
● Must comply with this manual's guidance, any
construction shall be performed by a professional
electrician,
unexpected risk !
● A circuit breaker must be set between the inverter
and the power supply to separate them, otherwise it
may cause a fire!
Danger
● Verify if power is a zero-energy status before
wiring, otherwise there is a risk of electric shock!
● The inverter shall be grounded correctly
according to standard specifications, otherwise
there is a danger of electrical shock!
● Ensure that the distribution line meets the
regional safety standards of EMC requirements.
Explanation
or component damaged are found,
otherwise there
2
would be the