Outback Power Systems MX60 Installation, Programming, And User's Manual page 76

MX60 is not equalizing
• Has the EQ cycle been initiated?
"EQ-MPPT" will be displayed.
• The EQ cycle has been initiated, but the battery is not equalizing.
ray or cloudy weather will delay the EQ cycle. Accordingly, running too many AC and/or DC loads
will delay the EQ cycle, too.
• An EQ set point that is too high relative to the battery voltage will delay the EQ cycle.
• If the PV array voltage is close to the battery voltage, the panels could be warm/hot causing the
Maximum Power Point to be at or lower than the battery voltage which can delay the EQ cycle.
MX60 Sweeping frequently
• A short sweep interval time will cause the MX60 to sweep frequently. A sweep interval of seven
to ten minutes is recommended.
• When the current limit set point is achieved, the MX60 will continue to sweep to maintain the
targeted current limit.
76
In the EQ Menu, press START to begin process. When the EQ cycle has been initiated,
The EQ cycle will begin when the target EQ set point voltage has been reached. A small ar
OutBack Power Systems Inc.