Backlight; Eq (Equalize) - Outback Power Systems MX60 Installation, Programming, And User's Manual

BACKLIGHT

BACKLIGHT CONTROL
EXIT AUTO ON
Charger
EQ
Logging
EXIT
EQ—BATTERY EQUALIZE
The intent of an equalization charge is to bring all battery cells to an equal voltage. Sealed batter-
ies should not be equalized unless specifi cally instructed by the manufacturer. Shut off or minimize
all AC and/or DC loads when equalizing and be sure the EQ voltage will not damage any DC load.
If possible, ensure the EQ cycle starts and stops the same day it is initiated or unnecessary battery
gassing can occur.
• Occasional equalization extends the life of fl ooded electrolyte batteries.
• Proceed with caution! A vent fan is recommended in enclosed spaces.
• The MX60 allows the user to set voltages and times of equalization process.
• Both manual and auto modes are available.
• EQ is not battery temperature compensated.
• Always check the electrolyte level in the batteries before and after equalizing.
34
ALWAYS
OFF
Aux *Light
Misc Optimize
Log2
GO
AUTO (default) leaves backlight and soft keys on for
60 seconds whenever any soft key is pressed (press-
ing any soft key when the LCD is not lighted does not
change any settings).
ON or OFF states are also available.
Press the #1soft key twice to return to the MAIN
Menu screen
Press the < > soft key to move the asterisk to the
EQ option. When the asterisk is to the left of EQ, press
the <GO> soft key.
OutBack Power Systems Inc.