Powering Up - Outback Power Systems MX60 Installation, Programming, And User's Manual

POWERING UP

The MX60 power-up sequence fi rst activates the unit and brings up a series of screens; some
screens allow the user to change the battery voltage.
Note: Be sure the PV input and battery breakers are off before starting the power-up sequence.
OFF SCREEN (this screen is initially blank at power up)
Figure 4
Note: The battery voltage must be at least 10.5 V or higher to power up the MX60. If the screen
reads "Got Battery?" please see the Troubleshooting Guide on page 74.
OutBack Power Systems Inc.
With the PV array and battery breakers off , press and
hold soft keys #1 and #3 and then turn on the battery
breaker (see Figure 4).
Battery Breaker
15