Setting Unit To Display Ppp While Pulse Welding (Dx And Lx Models Only) - Miller Maxstar 300 LX Owner's Manual

6-5. Setting Unit To Display PPP While Pulse Welding (DX And LX Models Only)

1 Output Switch Pad
2 Pulser Switch Pad
3 Power Switch
To access the PPP while welding dis-
play, turn power switch on, press and
hold the Output and Pulser switch pads
until software version clears meters
sel
1
And
and [SEL] appears. A and Pulser On
LED's will light.
4 Encoder Control
5 PPP Meter Display
Turn Encoder to change between stan-
dard and (PPP) meter display.
When the (PPP) meter display feature is
active while pulse welding, (PPP) is dis-
5
PPP
− − −
2
V
Rear Panel
played, and the meter hold feature is
disabled.
The (PPP) meter display feature will not
effect the normal amperage display or
Meter Hold capabilities when in a non-
pulse welding mode.
Press torch trigger or turn off power to
save setting.
4
3
Or
OM-2222 Page 47