Weld Output Terminals And Selecting Cable Sizes; Remote 14 Receptacle Information - Miller Dynasty 200 SD Owner's Manual

4-6. Weld Output Terminals And Selecting Cable Sizes*

!
Turn off power before
connecting to weld
output terminals.
!
Do not use worn, dam-
aged, undersized, or
poorly spliced cables.
+
−
Output Receptacles
This chart is a general guideline and may not suit all applications. If cable overheats, use next size larger cable.
*
**Weld cable size (AWG) is based on either a 4 volts or less drop or a current density of at least 300 circular mils per ampere.
2
( ) = mm for metric use
***Select weld cable size for pulsing application at peak amperage value.

4-7. Remote 14 Receptacle Information

A J
K
I
B
C L N
H
M
D G
F
E
* The remaining socketes are not used.
.
If a remote hand control, like the RHC-14, is connected to the Remote 14 receptacle, some current value above min. must be set on the remote
control before the Panel or Remote contactor is turned on. Failure to do so will cause current to be controlled by the panel control, and the remote
hand control will not function.
OM-2240 Page 20
Weld Cable Size** and Total Cable (Copper) Length in Weld Circuit
100 ft (30 m) Or Less
10 − 60% 60 − 100%
Welding
Duty
Amperes***
Cycle
100 4 (20)
150 3 (30)
200 3 (30)
15 VOLTS DC
REMOTE
OUTPUT
CONTROL
AMPERAGE
VOLTAGE
803 428-A
CHASSIS
Not Exceeding
150 ft 200 ft
(45 m) (60 m)
Duty
Cycle
4 (20) 4 (20) 3 (30)
3 (30) 2 (35) 1 (50)
2 (35) 1 (50) 1/0 (60)
Socket*
A Contactor control +15 volts dc.
OUTPUT
B Contact closure to A completes 15 volts dc
CONTACTOR
contactor control circuit and enables output.
C Output to remote control; +10 volts dc output to
remote control.
D Remote control circuit common.
E 0 to +10 volts dc input command signal from
remote control.
A/V F Current feedback; +1 volt dc per 100 amperes.
H Voltage feedback; +1 volt dc per 10 volts output.
G +15 volts dc GND
GND
K Chassis common.
250 ft 300 ft 350 ft
(70 m) (90 m) (105 m)
10 − 100% Duty Cycle
2 (35) 1 (50) 1/0 (60)
1/0 (60) 2/0 (70) 3/0 (95
2/0 (70) 3/0 (95) 4/0 (120) 4/0 (120)
Socket Information
400 ft
(120 m)
1/0 (60)
3/0 (95)
S-0007-E−