Ssata Configuration - Supermicro X10DSC+ User Manual

Chapter 4: AMI BIOS
EHCI2
Select Enabled to enable EHCI (Enhanced Host Controller Interface) support on
USB 2.0 connector #2 (-at least one USB 2.0 connector should be enabled for EHCI
support.) The options are Disabled and Enabled.
XHCI Pre-Boot Driver
Select Enabled to load Intel XHCI pre-boot driver. The settings are Enabled and
Disabled.

sSATA Configuration


When this submenu is selected, AMI BIOS automatically detects the presence of
the s-SATA devices that are supported by the PCH-sSATA controller and displays
the following items:
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel
PCH chip. The options are Enabled and Disabled.
Configure sSATA as
Select IDE to configure an sSATA drive specified by the user as an IDE drive. Select
AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select
RAID to configure an sSATA drive specified by the user as a RAID drive. The op-
tions are IDE, AHCI, and RAID.
*If the item above "Configure sSATA as" is set to AHCI, the following items will
display:
sSATA AHCI ALPM
Select Enabled for the sSATA controller to automatically generate link requests in
partial or slumber mode when there is no commands for the system to execute.
The options are Disabled, and Enabled.
sSATA Port 0~ Port 3
This item displays the information detected on the installed on the sSATA port.
specified by the user.
•
Model number of drive and capacity
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specified by the user. The options are
Disabled and Enabled.
4-17