Ruckus Wireless ZoneFlex Series Snmp Reference Manual page 42

MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Specifies the bss type."
::= { ruckusWLANEntry 3 }
ruckusWLANOperationalRateSet OBJECT-TYPE
SYNTAX OCTET STRING(SIZE(1..255))
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This attribute shall specify the set of data rates
at which the station may transmit data. Each octet
contains a value representing a rate. Each rate
shall be within the range from 2 to 127,
corresponding to data rates in increments of
500 kb/s from 1 Mb/s to 63.5 Mb/s, and shall be
supported (as indicated in the supported rates
table) for receiving data. This value is reported in
transmitted Beacon, Probe Request, Probe Response,
Association Request, Association Response,
Reassociation Request, and Reassociation Response
frames, and is used to determine whether a BSS
with which the station desires to synchronize is
suitable. It is also used when starting a BSS,
as specified in 10.3."
::= { ruckusWLANEntry 4 }
ruckusWLANBeaconPeriod OBJECT-TYPE
SYNTAX INTEGER (100..1000)
UNITS
"milli seconds"
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This attribute shall specify the number of milli seconds that a
station shall use for scheduling Beacon transmissions.
This value is transmitted in Beacon and Probe Response
frames."
Access Point WLAN MIBs
WLAN Table
42