To Identify Logical And Physical Network Interface Names While Installing The Solaris Os - Sun Microsystems Fire X4150 Installation Manual

Note – Use the procedure in this section if you are installing a version of the Solaris
OS. If you are configuring the preinstalled version of the Solaris OS, see
Network Interface Names for a Pre-installed Solaris OS" on page
▼ To Identify Logical and Physical Network
Interface Names While Installing the Solaris OS
1. In the Install Type menu, select Option (6) Single User Shell and press Enter.
If a message appears about mounting an OS instance, select q. You should not
mount any OS instance.
The message "Starting Shell" appears, see the following figure.
2. At the command prompt (#), type the following command to plumb all network
interfaces.
# ifconfig -a plumb
Note – The plumb process may take some time.
Appendix A Identifying Network Interface Names for Linux and Solaris OS Configurations
"Identifying
72.
75