Using The Direct Installation With Cd/Dvd Media And A Monitor; To Use The Direct Installation With Cd/Dvd Media And A Monitor; Using Direct Installation With Cd/Dvd Media And The Serial Port; To Use Direct Installation With The Serial Port - Sun Microsystems Fire X4150 Installation Manual

Using the Direct Installation with CD/DVD
Media and a Monitor
This procedure is for an installation using CD/DVD media and a monitor connected
to the server video port.
▼ To Use the Direct Installation with CD/DVD
Media and a Monitor
1. Insert the Solaris 10 OS CD/DVD media into the CD/DVD drive.
2. Power on the server.
The system boots from the Solaris 10 OS CD/DVD.
3. Follow the installation wizard to complete the installation.
Using Direct Installation with CD/DVD Media
and the Serial Port
To use the direct installation method with the serial port, you need to connect a
terminal (or terminal emulation device) to the server, start the service processor, then
configure the service processor to display the console output.
Note – In a normal install, you cannot use the console until after the installation is
complete. If a console is required, use the Jumpstart install described in
Using Jumpstart Network Installation" on page

▼ To Use Direct Installation with the Serial Port

Note – The SP in your system might be an ILOM or an ELOM. The differences are
noted in the procedure. See the corresponding ILOM or ELOM documentation for
additional information.
21.
Chapter 3 Solaris 10 Operating System Installation
"Installing
19