Roland VERSAUV LEC-300 Setup Manual page 44

6. Installing the Blade
3.
Install the blade holder.


Insert until the collar is
flush with the surface.

 Close the front cover, then press
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes the blade-
holder insertion hole to become gradually smaller, making installation difficult.
42
Screw
Screw
Support it from below.
Screw
Loosen the screw shown in the figure.
Support the screw from below and insert the blade
holder.
If installed without supporting the screw in this way, cutting quality
may become poor.
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
.