Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
1.4.6 (Optional) Setting a Shared Key for a RADIUS Server
1.4.7 (Optional) Setting the User Name Format Supported by a RADIUS Server
1.4.8 (Optional) Setting the Traffic Unit for a RADIUS Server
1.4.9 (Optional) Setting Retransmission Parameters on a RADIUS Server
1.4.10 (Optional) Setting the NAS Port Format of a RADIUS Server
1.4.11 Checking the Configuration

1.4.1 Establishing the Configuration Task

Applicable Environment
In remote authentication or authorization mode, you need to configure a server template as
required. You need to configure a RADIUS server template if RADIUS is used in the
authentication scheme.
Pre-configuration Tasks
None
Data Preparation
To configure a RADIUS server template, you need the following data.
No.
1
2
3
4
5
6
7
Issue 06 (2010–01–08)
NOTE
There are default parameters of a RADIUS server template, and the default parameters can be changed
according to the networking. You can modify the RADIUS configuration only when the RADIUS server
template is not in use.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
Data
IP address of the RADIUS authentication
server
IP address of the RADIUS accounting server
(Optional) Shared key of the RADIUS server
(Optional) User name format supported by
the RADIUS server
(Optional) Traffic unit of the RADIUS server
(Optional) Timeout interval for a RADIUS
server to send response packets and number
of times for retransmitting request packets on
a RADIUS server
(Optional) Format of the NAS port attribute
of the RADIUS server
1-11