Table of Contents
Advertisement
NITROGEN PRO 230A: 1. Frame Inspection
BEFORE ASSEMBLING YOUR NEW NITROGEN PRO, MAKE SURE THAT YOU HAVE ALL THE FOLLOWING:
1. Brakes and gears cables and housing set
2: Frameset parts checklist (see p.36)
3: Inspect the frame for cosmetic aspect (scratches, bumps, cracks, paint defect, etc.)
4: For reference, check serial number and write it on p.1
5: All the necessary bolts (refer to Frameset Parts, p.3)
6: For optimal shifting performance, use a dropout alignment gauge to make sure that the drive-side dropout is
straight (p.35)
IMPORTANT:
The following parts are assembled on the frame. When assembling the bike, you will need to adjust these parts according to their torque
specifications.
Parts installed on the frame
1
Front derailleur hanger
2
Rear derailleur hanger
3
Bottle cage
4
Bottom bracket cable guide
IMPORTANT: No more than 30mm of spacer can be place between the stem and the top cap of the 3D system.
And the use of more than 5mm spacer on top of the stem could void the efficiency of the compressor.
These practices will automatically cancel any warranty claim against the manufacturer.
Description
Screw (2)
Screw (2)
Screw (4)
Screw
Screw
Tork
Detail
type
Nm
3mm
4Nm
Loctite
3mm
4Nm
Loctite
4mm
3Nm
Grease
5mm
1.5Nm
Grease
2
Advertisement
Table of Contents
