Table of Contents
Advertisement
Checking the Fuses
The machine fuses are located under the control panel.
Access them through the side panel cover (Figure 64).
To open the side panel cover, release the 2 latches and
pull out on it.
Figure 64
1. Side panel cover
2. Latches
Cooling System
Maintenance
DANGER
Discharge of hot pressurized coolant or touching
hot radiator and surrounding parts can cause severe
burns.
• Do not remove the radiator cap when the engine
is hot. Always allow the engine to cool at least
15 minutes or until the radiator cap is cool
enough to touch without burning your hand
before removing the radiator cap.
• Do not touch radiator and surrounding parts
that are hot.
DANGER
The rotating fan and drive belt can cause personal
injury.
• Do not operate the machine without the covers
in place.
• Keep fingers, hands and clothing clear of
rotating fan and drive belt.
• Shut off the engine and remove the ignition key
before performing maintenance.
Checking the Cooling System
Service Interval: Before each use or daily—Check the
engine coolant level.
The cooling system is filled with a 50/50 solution of
water and permanent ethylene glycol anti freeze. Check
the level of the coolant in the expansion tank at the
beginning of each day before starting the engine. The
capacity of the cooling system is 6 quarts (7.5 l).
39
Advertisement
Table of Contents
