Toro 30381 Operator's Manual page 30

Figure 55
1. Attachment pin
5. If the attachment is powered by hydraulics, connect
the hydraulic coupler on the attachment to those on
the front lift arm.
Important: Ensure that the couplers are clean
before connecting them to prevent hydraulic
system contamination.
6. If the attachment is powered by the PTO, extend
the attachment PTO shaft and insert it onto the
machine PTO shaft (Figure 56).
Figure 56
1. PTO shaft
Note: To remove an attachment, perform the above
steps in reverse.
Engaging the Power Take Off (PTO)
The power take off (PTO) switch starts and stops
powered attachments.
1. If the engine is cold, allow the engine to warm up 5
to 10 minutes before engaging the PTO.
2. Cotter pin
2. While seated in the seat, release the pressure on the
traction control levers and place them in neutral.
3. Pull up on the PTO switch to engage it (Figure 57).
1. PTO switch
Disengaging the PTO
To disengage, push the PTO switch to the off position.
30
Figure 57