Table of Contents
Advertisement
1. Floor plate
7. Slide the drive shaft onto the gearbox shaft
(Figure 10). Install the roll pin and torque the bolts
to 175-225 inch pounds.
1. Drive shaft
2. Gear box
8. Route and connect the hydraulic pressure and tank
hoses to the valve (Figure 11).
Figure 9
Figure 10
3. Bolt
4. Roll pin
1. Control valve
2. Tank hose
9. Install the rear of the deck lift cylinder onto the pivot
pin and secure with the retaining ring (Figure 12).
10. Secure the front of the lift cylinder to the mower
frame with the cylinder pin and screw (Figure 12).
1. Deck lift cylinder
2. Retaining ring
11. Position the ROPS assembly onto the ROPS posts.
Install the bolt, nut, hair pin cotter and pin securing
each ROPS assembly to the ROPS posts (Figure 13).
Note: If installing an allied suppliers mower deck,
ROPS Kit, part no. 117– 9179 must be installed.
12
Figure 11
3. Pressure hose
Figure 12
3. Screw
4. Cylinder pin & screw
Advertisement
Table of Contents
