Table of Contents
Advertisement
1. 3/4 inch bolts
Note: The rear tires will need to be removed to
torque the rear bolts (3/4 inch). After torquing the
frame bolts, install the rear tires and torque lug nuts
to 65 to 85 ft-lb (88 to 115 N-m).
9. Insert a rubber mount onto each cab mount at the
rear mounting locations (Figure 22).
1. Cab mount
10. Lower the cab into position by slowly and evenly
loosening the jacking bolts on each end of the
jacking tube (Figure 23).
Figure 21
2. Coupler pin
Figure 22
2. Rubber mount
1. Jacking bolts
11. At the rear mounting points, secure the cab to the
machine with a bolt (1/2 x 3 inches), steel washer
(1/2 x 2–1/2 inches), rubber washer (1/2 x 2–1/2
inches) and nut (1/2 inch) (Figure 24). Tighten all
four cab mount bolts until the rubber mounts are
compressed to a thickness of 7/8 inch (2.2 cm).
1. Rubber mount
12. Tighten the bolts and nuts securing the rear cab
mounts to the ROPS posts (Figure 25 ). Adjust the
floor jack if the bolts are binding and difficult to
remove.
15
Figure 23
2. Cab jack tube
Figure 24
2. 0.875 inch (2.2 cm)
Advertisement
Table of Contents
