Checking The Electrical System; Checking The Fuses - Toro LT2240 Operator's Manual

temperature conditions, the battery electrolyte may
require adding water.
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35).
2. Unlatch and open the hood.
3. At the left side of the machine, slip back the
battery terminal insulators
Figure 70
4. Remove any corrosion from the battery terminals
using a wire brush and to prevent further
corrosion.
Note:
Check the condition of the battery cables.
Install new cables when current ones are
showing signs of wear or damage, and tighten
any loose connections.
5. Apply Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to the terminals.
6. Clean the battery compartment.
7. Close and latch the hood.
(Figure 70).
g348735
g348736
45
Checking the Electrical
System
Service Interval: Every 500 hours
Inspect all electrical connections and cables and
replace any which are damaged or corroded. Spray a
good-quality water inhibitor onto exposed connections
to prevent moisture ingress.

Checking the Fuses

1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
35).
2. Unlatch and open the hood.
3. At the back of the bulkhead, remove the
fuse-block cover
Figure 71
1. Fuse holder (maxi fuse)
2. Maxi fuse-holder cover
4. Check for open fuses.
5. Replace any open fuse with a fuse of equal
amperage capacity
(Figure 71)
3. Fuse-block cover
4. Fuse block (ACT/ATO
blade)
(Figure 72).
g348552
g348551