Operating Front Attachments With The Polar Trac Kit Installed - Toro 30381 Operator's Manual

all necessary lighting and marking as required by
law. Please carefully read all the safety instructions.
Knowing this information could help you or bystanders
avoid injury.
To transport the machine:
• Ensure that your vehicle, hitch, safety chains, and
trailer are adequate for the load you are pulling and
that they meet all local traffic regulations for your
area.
• Lock the brake and block the tracks/tires.
• Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes as required by
local traffic regulations in your area (Figure 53).
Figure 53
1. Front tie-downs
Operating Front Attachments
with the Polar Trac Kit
Installed
Changing the Attachment Orientation
Use the attachment control pedals (Figure 54) to
control the physical orientation of the attachment. Use
the left pedal to raise and lower the attachment. Use the
right pedal to swing the attachment to the right or left.
Note: The right pedal is not used on all attachments.
Also, on snowthrowers, only the chute swings right
and left.
2. Rear tie-down (left side
shown)
1. Press to lower the
attachment/lift arm
2. Press to swing the
attachment to the left
Important: Do not continue to hold a pedal after
the attachment has finished moving. Doing so will
damage the hydraulic system.
Connecting/Disconnecting an
Attachment
Read the Operator's Manual supplied with the attachment
before operating.
1. Lower the front lift arm.
2. Drive the machine into position behind the
attachment adapter.
3. Raise the machine adapter on the lift arm into the
attachment adapter.
4. Secure the adapters together with the attachment
pin and hairpin cotter as shown in Figure 55.
29
Figure 54
3. Press to raise the
attachment/lift arm
4. Press to swing the
attachment to the right