Table of Contents
Advertisement
1
2
5
Figure 13
1. ROPS
2. Pin
3. Cotter pin
12. Start the machine, raise and lower the deck. Check
for leaks and make sure the hoses do not rub against
the frame.
Installing the Polar Trac Kit
1. Remove the traction unit from the shipping pallet.
2. Place a jack stand under each wheel motor and a
floor jack under the rear bumper (Figure 14) or
suspend from a over head hoist.
Figure 14
1. Rear bumper
3. Remove the two screws securing the winter frame
floor plate cover to the floor and remove the plate
(Figure 15).
4
3
G004634
4. Bolt & nut
5. ROPS post
2. Floor jack
1. Floor plate cover
4. Carefully roll the winter frame assembly into position
while routing the drive shaft through the frame tube
(Figure 16).
1. Drive shaft
Note: If the rear of the cab is not high enough to
clear the control handles, evenly tighten the jacking
bolts on each side of the cab jack tube to raise the
rear of the cab (Figure 17).
13
Figure 15
2. Mounting screws
Figure 16
2. Frame tube
Advertisement
Table of Contents
